- Process Simulation & Process Optimization
- Flow Sheet development with Heat and Material balances
- Preparation of PFD and P&ID
- Specifications for Process Equipment and Instruments
- Basic Engineering Package for Process Units, Utilities
- Conceptual Top-side Layout
- Process Control Philosophy
- Process Shutdown Philosophy (Normal & Emergency)
- Cause and Effect Diagram
- Assistance for HAZOP Studies
- Detail Layout for Overall Topside
- Equipment Layout Drawings
- Piping Materials Specifications
- Specifications for Specialty Items
- Piping General Arrangement (GA)
- Piping Isometrics
- Pipe Stress Analysis.
- Pipe Support Design
- Material Take Off (MTO)
- Selecting and specifying:
- Compressors, Blowers & Fans-Pumps
- Turbines & Engines
- Preparation of Data Sheets and Purchase Specifications
- Requisitioning and Review of Vendor Drawings/Specifications.
- Vibration Analysis
- Design, modeling and analysis- offshore structures
- Structural Analysis
- In-place- In-service- Transportation-Heavy lift
- Design of modular structures, integrated units, multilevel units
- Structural Drafting
- Bill of Quantities and material specifications
- Local and Global strength analysis, hydrodynamic - model analysis
- Load outs, float off, float over analysis
- Instrumentation Design Basis
- Control Philosophy and Specifications
- Detailed Engineering and Specifications for:
- Distributed Control Systems
- Programmable Logic Controllers
- Emergency Shut Down Systems
- Fire and Gas Detection System Philosophy and Specification
- Sizing of Control Valves, Flow Elements, Safety Valves, etc.
- Data Sheets/Specifications for Instruments, Control Valves, Safety Relief Valves etc.
- Instrument Bulk Material Take-off
- Cable Selection and Scheduling
- Control Room Design including Panel, Console Layouts
- Cable Tray Layout and Conduit Routing
- Instrument Installation Hook-ups
- Instrument Loop Diagrams
- Instrument Indexing
- Review of Vendor Drawings and Documents
- Power System Studies:
- Load Flow
- Short Circuit
- Motor Starting etc
- Power Generation and System Design
- Single Line Diagrams (SLDs)
- Protection Relay Coordination Diagram
- Cable System Design, Scheduling and Take - off
- Lighting System Design
- Uninterrupted Power Supplies (UPS) - Design and- Specification
- Cable & Equipment layout
- Electrical Terminal Connection Diagram
- Requisitioning and Review of Vendor Drawings/Specifications
- HSE PHILOSOPHY
- HAZARDOUS AREA CLASSIFICATION
- ACTIVE FIRE PROTECTION
- FIRE ZONE DEFINITION
- FIRE WATER DEMAND CALCULATION
- FIRE WATER PUMP SIZING
- DELUGE P&IDs
- FIRE FIGHTING & LIFE SAVING EQUIPMENT LAYOUTS
- PASSIVE FIRE PROTECTION
- SAFETY STUDIES SCOPE OF WORK & METHODOLOGY
- TECHNICAL SPECIFICATIONS
- DATASHEETS
- KEY SAFETY STUDIES
- QUALITATIVE(HAZOP & HAZID)
- QUANTITATIVE(SIL, QRA, FERA , SCE-I & PS, COLD VENT GAS DISPERSION, FLARE RADIATION Studies)
- OTHERS
- NOISE & VIBRATION
- FIRE WATER HYDRAULICS & SURGE ANALYSIS
- Demolition Engineering
- Vessel Condition Evaluation
- Remaining Life Extension
- Hull Under Deck Strengthening – Analysis and Design
- Marine Conversion
- Accommodation & Helideck
- Sewage System
- Water Maker System
- Slop Tanks; Open & Closed Drains
- Fire Water System
- Marine Conversion
- Foam System
- Fire & Gas
- Tank Systems
- Relocation of Suctions & Vents
- Tanker Offloading System
- Produced Water Discharge
- Sea Water Lift Pumps
- Fresh Water, DM Water, Service Water Systems
- Winches
